AUTOFLO MODEL SC-15 |
|
How Does a Model SC-15 Work?The SC-15 is mounted to the heating plenum of your furnace. A water line is tapped into your home's water pipes and attached to the SC-15 Humidifier. A Humidistat (Relative Humidity Sensor) is placed somewhere in the house to sense the dryness of the air in the home. The Humidistat will send a signal to the Humidifier to turn on when the air in the house is too dry. The water is now turned on to the humidifier and drains through an Evaporator Pad. When the water is draining through the pad the Hot Dry air from your furnace is forced through the Evaporator Pad. The air picks up moisture from the pad and delivers it into your living area. |
Model SC-15 Specifications An important step forward in humidifier engineering enables the SC-15 to offer easier installation and lower maintenance than any other humidifier on the market. This "Revolutionary" design reguires only one plenum hole to be cut into your duct work, most humidifiers require two. The SC-15 accomplishes this by using an air diverter on the back of the humidifier that forces the hot, dry air from the supply duct into the humidifier and across the high capacity media pad to pick up moisture and then releases that air back info the air stream to be delivered to your living area. This design also eliminates any "summer" maintenance that needs to be done by the homeowner that all other humidifiers require. Model SC-15 can be used with any forced air furnace and mounts on the warm air supply.Capacity-gph .68 SQ. FT. Area 2,400 Unit Size 13" x l3" Plenum Opening 11" x 11" Electrical Data 24V 60Hz Also Included:
|
