AUTOFLO MODEL 200P

model200P.jpg (13651 bytes)

 

 

How Does a Model 200P Work?

 how200p.jpg (6709 bytes)

The 200P is mounted to the heating plenum of your furnace. A water line is tapped into your home's water pipes and attached to the 200P humidifier. A Humidistat (Relative Humidity Sensor) is placed somewhere in the house to sense the dryness of the air in the home. The humidistat will send a signal to the Humidifier to turn on when the air in the house is too dry.

The water is now turned on to the humidifier and fills a water pan that has an Evaporator Pad rotating through the water. When the water is draining through the pad the Hot Dry air from your furnace is forced through the Evaporator Pad. The air picks up moisture from the pad and delivers it into your living area.

 

 

Model 200P Specifications

The drum type by-pass construction of the Model 200P is made of stainless steel for durability and longevity. This humidifier can be used with any forced air furnace and is ideal for most of today's new homes. The 200P utilizes Autoflo's patented "Convair Cone" which increases the air flow through and around the water media in the humidifier to maximize it's capacity.

Capacity-gph: .58

SQ. FT. Area: 2,200

Unit Size: 16" W x l1" H x 9" D

Plenum Opening: 8" diameter half-circle

Electrical Data: 24V 60Hz, 3 watts

Also Included: